This page:

Oil & Filter Change On The 4C.

	Undo the screws that secure the alloy under tray.
	loosen the 13mm sump bolt so the it slow drains into a suitable container. Remove the bolt, replace the sump washer and screw back into the sump.
	Remove the oil filter which sits just above the right hand rear drive shaft cup with an oil filter wrench (there's not much room).
	Wipe the face of the housing, smear clean engine oil over the rubber seal of the new filter and screw in hand tight.
	Replace the under tray.
	Pop the boot release.
	Prop the boot up with the sophisticated tool supplied by Alfa.
	Unscrew the filler cap.
	Fill up with 5 litres of the recommended oil and replace the cap.
	Briefly run the engine then locate the yellow dip stick plug and remove.
	Wipe the dip stick, replace then remove, repeat again for a true reading and top up as required.
If you are an existing online parts customer of ours, you can get Further Technical DataIf you are unsure about your login details, have a look at the bottom of previous emails from us. If you no longer have these emails, click through this link and then on the "Forgotten Password" link, using the email that you used for the last purchase (usually the email address you use for PayPal). If you still have problems, don't set yourself up as a new user as this new user won't have the purchase history to allow access to the technical data. Just send us an email instead.