This page:

How to replace an idle control steeper motor on a CF2 engine

How to replace the idle stepper motor

border='1'

Undo the three screws that secure the idle stepper motor

border='1'

Pull the unit off the throttle spindle and then disconnect the plug

border='1'

Remove the unit and replace using the reverse of the procedure above, making sure that you engage the spindle on the correct side of the spring

border='1'

Re set the self adaptive parameters using the correct diagnostic equipment.

border='1'If you are an existing online parts customer of ours, you can get
Contact Us | General Interest | Alfa Insurance| New Alfa Romeos | Club Corner | Terms & Conditions | © Jamie Porter Ltd