COVID-19 Message Updated: 22nd March
Mail Order Customers:
  *
Our carrier DHL is operating near normally across the world with its Air Express service. Allow an extra day for delivery (4 days for Australia and New Zealand), just in case.
  * For the UK only, Royal Mail are delivering the vast majority of orders on time according to our data, but is experiencing higher levels of staff absences, so there may some local delays.
  * We will be working normally and have a large warehouse full of parts that will help keep your car on the road. However, we are seeing some supply delays from factory lockdowns around the world.
Workshop Customers:
  *
Following government guidance, we are open as usual. Taking your vehicle to a garage for repairs is a permitted activity (safety) as long as you observe the social distancing rules. We have strict social distancing processes internally and disinfect daily (not least because we have staff in vulnerable groups). In the circumstances, we have had to close our waiting room. Our mechanics wear gloves at all times and we will disinfect your vehicle with our Zaflora sprays on handing back to you. We would respectfully ask you to show our staff the same courtesy. We also have full amount contactless payment systems.
  * MOTs due for renewal from 30th March to 31st July 2020 were extended for six months. There have been no MOT extensions since then. After the first lock-down, the massive pent-up demand for MOTs overwhelmed supply so even if you don't need to use your car in this current lock-down, it is still strongly recommended to get one done should your vehicle be needed at short notice.







This page:


/

Replacing the EGR valve

Replacing an EGR valve

border='1'

Remove engine top cover and then disconnect this clip if fitted on your model.

border='1'

Then this one

border='1'

Disconnect the power supply to the EGR valve.

border='1'

Undo the bracket that retains the pipe.

border='1'

Remove the heat shield over the valve.

border='1'

Disconnect this clip

border='1'

Undo the two bolts on top of the EGR valve

border='1'

and then the ones on the side of the EGR valve and the valve will come off. When replacing the EGR valve it is best to fit the modified gasket if it hasn't already been fitted.

border='1'If you are an existing online parts customer of ours, you can get
Contact Us | General Interest | Alfa Insurance| New Alfa Romeos | Club Corner | Terms & Conditions | © Jamie Porter Ltd