COVID-19 Message Updated: 22nd March
Mail Order Customers:
  *
Our carrier DHL is operating near normally across the world with its Air Express service. Allow an extra day for delivery (4 days for Australia and New Zealand), just in case.
  * For the UK only, Royal Mail are delivering the vast majority of orders on time according to our data, but is experiencing higher levels of staff absences, so there may some local delays.
  * We will be working normally and have a large warehouse full of parts that will help keep your car on the road. However, we are seeing some supply delays from factory lockdowns around the world.
Workshop Customers:
  *
Following government guidance, we are open as usual. Taking your vehicle to a garage for repairs is a permitted activity (safety) as long as you observe the social distancing rules. We have strict social distancing processes internally and disinfect daily (not least because we have staff in vulnerable groups). In the circumstances, we have had to close our waiting room. Our mechanics wear gloves at all times and we will disinfect your vehicle with our Zaflora sprays on handing back to you. We would respectfully ask you to show our staff the same courtesy. We also have full amount contactless payment systems.
  * MOTs due for renewal from 30th March to 31st July 2020 were extended for six months. There have been no MOT extensions since then. After the first lock-down, the massive pent-up demand for MOTs overwhelmed supply so even if you don't need to use your car in this current lock-down, it is still strongly recommended to get one done should your vehicle be needed at short notice.







This page:


/

Removing The Bumper And Headlights From A Brera

If you're not just planning on removing the bumper for a respray or because of the last road kill but need to replace a headlight or radiator instead then you need to follow this first. This "How To" is based on the 3.2 JTS.

border='1'

Remove all of the undertray fixings.

border='1'

Undo the two Phillips screws on the wheel arch liner,

border='1'

and the 8mm top bolt on both sides.

border='1'

Along the top of the bonnet slam panel undo the four T27 (Torx) screws.

border='1'

Pull the sides of the bumper away from its clips.

border='1'

The bumper is now free apart from unplugging the two fog light connectors.

border='1'

To remove the headlights undo the two T27 screws on top,

border='1'

and the one at the bottom,

border='1'

then unclip the headlight connector.

border='1'

If you now want to remove the radiator go to Brera radiator removal.

Related Links: Diagnostics | Service schedule

Contact Us | General Interest | Alfa Insurance| New Alfa Romeos | Club Corner | Terms & Conditions | © Jamie Porter Ltd